Use the ON CONNECT/PACK command to run a command file before or after connecting to or packing a database.
Options
BEFORE
Indicates the command file should be run before the CONNECT/PACK.
CONNECT
Indicates the command file should be run when connecting a database.
FIRST
Indicates the command file should be run on the first connect only.
PACK
Indicates the command file should be run when packing a database.
RESET
Clears out the ON CONNECT/PACK command recorded in the database.
cmdfile
Specifies the name of the command file to execute.
SAVE
Specifies that the parameters in the cmdfile or from the RESET will be saved to the database. Any options without the SAVE parameters will only be active for a session.
About the ON CONNECT/PACK command
The ON CONNECT/PACK command is useful for running a specific command file whenever a database is connected or packed. A common use would be to run a command file that does an AUTOCHK command before connecting. The ABORT ON command could then be used to cause the CONNECT/PACK to be aborted after the command file finishes.
